“Light” a Paper Menorah

Even the youngest child can light a paper menorah!

Now that Thanksgiving is over, it’s time to start getting ready for Chanukah! I wanted to make something for kids who are old enough to know that we light a menorah on Chanukah but who are not old enough to be trusted with actual fire. Enter this paper menorah.

Start with a blank menorah. Draw your own (don’t forget flames!) or download the template here. We decorated our menorah by gluing on squares of tissue paper, which the kids really enjoyed but of course you could use markers, crayons or whatever you prefer . When it dried, we cut it out and then used paper fasteners to create flames that can be rotated upwards it’s time to “light” them.

Where are all the flames?

Tada! It’s the third night of Chanukah!

We use cardstock for our menorah which turned out not to have been a smart choice when if came time to attach the flames. The paper fasteners are not strong enough to poke through it on their own so I had to laboriously pre-poke holes in both the menorah and the flames and rotating the flames is a bit tough when done. Just use regular paper and you should be fine.

Looking for more Chanukah projects?
Nature Menorahs
“Spinning” Paper Dreidel
Decorate a Dreidel…with a Dreidel!

Lighting Paper Menorahs

Time:
Active: 15 minutes for decorating, 10 minutes for assembly by adult
Drying: 15 minutes+ if using paint or glue

Age: 2-8

Materials:
Drawing or printout of menorah and flames. Download the template here.
Something with which to decorate the menorah – we used squares of tissue paper and glue but paint, markers, crayons, or stickers would be great too.
Scissors
9 paper fasteners

Process:
Print out the template or draw your own menorah and decorate. Don’t worry if you go out the lines because it will be cut later. Let dry if needed.

Cut out the menorah and flames. We decided not to cut in between each branch since once the paper fasteners were attached they would weigh down the flimsy branches.

Attach flames by poking the paper fasteners from front to back. Turn over your menorah and decorated side facing out, slide the flame on to the fastener. Open fastener flaps and make sure flame can rotate.

When you have all of the flames attached, here is what it should look like:

Did you do this project? Share your pictures on our facebook page!